How do you fix red and white flash on Puffco pro?
Please try first removing and cleaning the chamber from the device. Submerge the chamber in 90%+ Isopropyl Alcohol for 20 minutes. Never use water – 99% ISO only!). Make sure that the chamber has thoroughly air dried before reattaching.
The red flashing light is to indicate that there is a short circuit somewhere in the device. Contact support@puffco.com or Puffco.com/warranty for further assistance.
The rainbow light is an indication that there is a connection issue between the base and atomizer & does not necessarily mean that anything is broken or defective. The first tip is to remove the atomizer, clean the connection pins with a cotton swab dipped in iso and reattach the atomizer.
Be sure to reset both your phone and device as well; you can reset the device by holding the power button down for 20 seconds consecutively.
Most wax atomizers Coil will need to be replaced within 1-4 weeks and can last up to 12 weeks. This number depends on how often you vape, and the temperature you choose. Many of us who vape constantly at high temperatures will need to replace their atomizer more frequently.
In some cases this can simply be a bug with the base that can be resolved by resetting the device. If the cleaning doesn't do the trick please try holding the power button down for 20 seconds. Upon letting go, the device should reset and restart.
Not to worry, this is simply an indication that your chamber is not attached. Please try removing the chamber from the base and reattaching, making sure the chamber is fully seated and attached to the base.
My Battery Light Just Flashes When I Try To Use It, What Should I Do? This is usually the result of a connection issue. Sometimes even the smallest bit of debris can cause a bad connection which stops the pen from working at it's full potential.
If the battery is functioning as intended and your chamber won't heat you may be experiencing a connection issue. In this case we always recommend cleaning the gold connection pins located on the top of the battery and the underside of the chamber.
The red-blue flashing response from your Peak Pro is a sign of a chamber connection error. Please try first removing and cleaning the chamber from the device. Submerge the chamber in 90%+ Isopropyl Alcohol for 20 minutes.
How do you fix Puffco rainbow lights?
Puffco Peak Rainbow Lights? - Atomizer Check - YouTube
Atomizer can be cleaned by submerging fully assembled part in Isopropyl Alcohol (99% preferred). DO NOT RINSE WITH WATER, AS WATER EXPOSURE TO CERAMIC CAN POTENTIALLY DAMAGE THE PART. Be sure to clean the gold connector pin on the base and bottom of atomizer with Iso soaked cotton swab as well.

Wait - you can vaporize dry herbs!
Vaporizing isn't just for concentrates, and you don't have to smoke your dry herbs. You can go straight to the source and vaporize whole flowers with a dry herb vaporizer.
- Soak atomizer in 99% isopropyl alcohol to remove any oil from inside the atomizer. ...
- There is a wire welded on the bottom of the atomizer. ...
- Push the Puff Coil Repair pick in between the ceramic ring and the metal ring. ...
- You may need to move the pick in and out a couple times before you have a good lock on the ring.
Puffco Peak Atomizer fix - YouTube
3 red flashes: Indicates low battery. 5 light flashes: Indicates short circuit. Red light holds: Device overheated.
The atomizer separates into four different pieces but to prevent any damage, Puffco recommends keeping it all together and dropping it into some rubbing alcohol to soak.
Drop the oven chamber and the dart in some rubbing alcohol and let them soak for a few hours. This Puffco Plus is ready for a deep cleaning! In the meantime, dip a cotton swab in some rubbing alcohol and swab any sticky gunk off the inside of the metal mouthpiece housing.
Often, something like this can be a bug that can be resolved by simply resetting the device. If you're unable to get the device to charge, please try shutting the device down completely (hold the button for 3-6 seconds until you feel the device vibrate and power down) and then attaching to the charger.
So, can you use the Puffco Peak while charging? Well, technically yes though it's not recommended. You can get a dab out of it, but the Peak won't actually be charging since all the power will be used to heat it up.
Why do Puffco peaks blink 5 times?
The 5x flashing light is to indicate that there is a short circuit somewhere in the device. Contact our support team for further assistance.
If you see a white flashing light, the police may be using it as a warning but are more likely to be trying to identify a particular vehicle or to illuminate your vehicle or one in your vicinity, and you do not need to stop or pull over unless they use their tactical blue and red lights.
Puffco Peak Atomizer fix - YouTube
Atomizer can be cleaned by submerging fully assembled part in Isopropyl Alcohol (99% preferred). DO NOT RINSE WITH WATER, AS WATER EXPOSURE TO CERAMIC CAN POTENTIALLY DAMAGE THE PART. Be sure to clean the gold connector pin on the base and bottom of atomizer with Iso soaked cotton swab as well.
Battery and charging
So, can you use the Puffco Peak while charging? Well, technically yes though it's not recommended. You can get a dab out of it, but the Peak won't actually be charging since all the power will be used to heat it up.